DERIVABLE Interactive Special Effects Frames Panel
Do NOT buy this product! It is meant for developers to derive from only
Each panel is sized proportional to the needs of the DOC - it's even tilted so that your camera will make it appear to be a perfect rectangle. Just position the frame in front of your avatar and snap the picture!
Special effects frames include Burndt Edges, Electrify, Flames and Bubbles.
The following describes the interactive part of this product. It can be used as-is, or altered for your own product pages.
The fully interactive panel changes at your command.
The keywords are included on a helpful panel right on the product. The help panel can be turned off in case it gets in your way.
Commands: help1 - shows the help panel help0 - hides the help panel
Frame commands:
frame0 - turn all frames off (not sure why you'd want this, but here you go)
frame1 - turn on frame 1, bigger version
frame2 - turn on frame 2, bigger version
frame3 - turn on frame 3, bigger version
frame4 - turn on frame 4, bigger version
frame5 - turn on frame 1, smaller version
frame6 - turn on frame 2, smaller version
frame7 - turn on frame 3, smaller version
frame8 - turn on frame 4, smaller version
Troubleshooting:
If the help panel at the top reads "Back Panel - Rotate Panel" then the item is facing backwards and will be tilted the wrong way. When you line up the camera for a photo, it will NOT appear rectangular.
NOTE: All images below are SAMPLES to show the size/position of the frame. The actual derived product contains black and white image, not the flowered images shown below.
For example:
Correct Angle (Frame leans in at top)
Wrong Angle (Frame leans away at top)
To fix this (also see Figure 1 below):
* Switch to "edit" mode in your room (click the "hammer" icon)
* Switch to "rotate" mode (the circular arrow)
* Hover over the frame until the "rotate" icon appears
* Click and drag left or right until the frame "snaps" into place, facing the right way
* Exit "edit" mode
